国内下订很麻烦的,因为AP不支持国际的ONLINE ORDER。你是怎么订的?
只是在AP的网站上登记一个表,不需要下订金的,排到你了后它会用邮件通知你是不是确定要,要的话在下50%的订金,然后等一年左右就可以得到了。
AP130F6的镜子我在香港巨眼见过,第一感觉就是大,我没有想到这个规格最小的镜子都这么大! AP的代理说,最后能交钱的,不足30%,所以也是AP的东西迟迟开不了工的原因。 AP 的resell value 和 reputation 最好。 楼上很久不来了吧,记得也订过AP镜子,可到手了? 是很久没有来了,似乎比以前冷清了些。
关于AP的镜子,因为是2000 年4月登记的,而上批只到99年10月,所以还没轮到。时间长了也不着急。 真有耐心 因为手头上有其他镜子,傻等可不行。 即使这样时间也够长,总算是快等到。手头现在用什么? C9.25 and 80ED
谁能把ap130edfs
与 TOA130 by Takahashi 做一个对比回复: 谁能把ap130edfs
最初由 da 发表与 TOA130 by Takahashi 做一个对比
这两个镜子除了口径相同外,根本就不是一类东西。
AP 130相对F值才F6, TOA则是F7以上,看深空当然是AP优,而且AP只有区区6.8kg,几乎是这个规格的极限了,而TOA则有10kg以上。
此外两者的做工也不能比较。
所以比较这两个镜子没有意义。 其实,买AP130,还不如TMB130 。
1,tmb的外形,做工,cnc镜筒感觉好于ap
2,ap的镜子有油层,搞不好漏油了不是惨了。
3,tmb到货比ap快好多。 楼上说的,除了第三点外,不同意。
首先CNC的TMB多重啊?11公斤,加上mount ring,要超过13公斤。
关于AP的镜子油层根本不用担心,因为那个油非常少,通常只需要一滴就可以了。 首先ap用的不是油镜头。就算是油镜头,以他们精益求精的技术,大可不必担心会漏油。 油是靠毛细现象保存在镜片中间,除非拆开,否则不会漏。
AP 新设计的6“ APO 准备用空气分离,可以全部用球面,减少手工改正,提高产量,降低resell value。
OIL-SPACED LEN: A Message From Roland Christen
The oil is not really sealed in between the lenses. It stays in by capillaryaction. If any problems occur, they can be readily fixed by separating the
lenses and re-oiling them. The glass itself never changes and stays pristine
between the elements. No dirt can ever invade in the space between the elements.
Problems can occur in an airspaced lens also where fungus can attack the
coatings in between the lenses. Dew and moisture can settle between the elements
and cause discoloration and in worst cases can etch the surface over the long
term.
Roland Christen
页:
1
[2]