求指导，skysafari
已经连接成功，但是那个取景的窗口不动。而且不能对准，情况如下，求解！这是啥机器？看不懂 给大家点详细信息，什么赤道仪，装的什么驱动，就两张图能看出来啥呢 beisen 发表于 2014-7-17 22:43
这是啥机器？看不懂
这是个软件。。skysafari pro 1.5.1。坛里有的
宇宙好神奇 发表于 2014-7-17 22:46
给大家点详细信息，什么赤道仪，装的什么驱动，就两张图能看出来啥呢
赤道仪就是nexstar 6se的那个单叉臂，没装啥驱动。。平板电脑上蓝牙控制呢。。宇文版主有个帖子，你可以去参考一下
看错误提示貌似是望远镜的实际指向和星图认为的指向差距太大，参照heq5 校准的经验，校准第一颗星的时候可以先用手动粗调再用手柄细调
本帖最后由 cosmosEX 于 2014-7-18 03:05 编辑
Align: This synchronizes the scope to coordinates of the selected object. The bullseye indicated in the sky chart shows where the telescope thinks it is pointing. If that appears incorrect, the scope and the software must be aligned. To do so:
[*]Physically center the scope on a real object in the sky.
[*]Select that object in the sky chart to make it the current target object.
[*]Tap the Align button.
You can re-align the scope and the software anytime there is a discrepancy between the two.
Note: for Celestron NexStar and Orion/SkyWatcher SynScan telescope controllers, tapping the Align button stores the offset between the telescope's reported position and the selected object's position. It subtracts that offset from the telescope's reported position whenever the telescope is within 10 degrees of the object you Aligned on. In other words, SkySafari performs a "local sync" around the alignment target. If you move the telescope to a very different part of the sky, you may want to Align on a target in that part of the sky. Also note that the telescope's RA/Dec reported by SkySafari will differ from the RA/Dec reported by its hand controller (since SkySafari is applying the alignment offset to the telescope's reported position.)
确保首先用手柄或slew把望远镜指向校准目标，然后才在Sky Safari Pro里选择目标校准。
SkySafari的帮助在这里，当然说明在软件里都有。http://www.skysafariastronomy.com/support/index.html 宇文蓝枫 发表于 2014-7-18 00:00
对齐能力是有限的不是说离得很远都能都对齐的 只有在一定范围内才能对齐目标 ...
那这个怎么解决呢。。 cosmosEX 发表于 2014-7-18 03:09
SkySafari的帮助在这里，当然说明在软件里都有。http://www.skysafariastronomy.com/support/index.html ...
谢谢！ 已解决！谢谢各位！
页:
[1]