本帖最后由 饺子 于 2011-5-11 12:29 编辑
之前几次出去拍星磨合设备,魔子200一直在赤经上有吱的声音,有一次玩了一晚上,么有声音了,但是这次去满顺,吱的声音又来了,基本的位置在这里,这是给高桥的问题位置图片~
于是,昨天下午闲着无聊,跟上海的小顾订货的时候,顺便沟通了一下这个情况,小顾也很负责任,第一时间给高桥发了邮件,没有想到今天下午小顾就告诉我高桥有回复了,并且还是图文方式的解释,不由佩服日本人的敬业和服务。具体原文如下:
Our technical section people would like you to check the clearance gap (picture step 1) very carefully whether the gap is enough or not on around the ring in comparison with other points. If there is a too small gap like being in touch, the noise may come from that point.
To make it correctly, please follow the following steps 2 to 5.
Step 2 : Please adjust the two indicators as shown on picture step 2, and tighten the hand set screw.
Step 3 : Using 0.9mm Allen wrench, loose the set screw.
Step 4 : Insert the hard paper to three points to be equal gap.
Step 5 : With adjusting the indicator to 0 point and up holding toward yellow arrow on picture 5, tighten the set screw with 0.9mm Allen wrench.
According to our technician, the noise may disappear, but if not, please let us know again. If you do not have the 0.9mm Allen wrench and the hard paper, do not hesitate to ask us and we will send immediately.
With our best regards,
Takeshi Kunii, Director
Associated Manufacturers' Agency 晚上回到家,家里的螺丝还真没有0.9mm的小扳螺丝,但是基本上的意思明白,也不按照那个方法了,直接找两张名片,按照第四步,插到黑环里,旋转几下赤经,然后可恶的吱吱声就消失了。
在这里首先感谢上海的小顾,感谢Takeshi Kunii先生,希望日后买魔子200的同好,如果出现此问题,可以参考这个办法。
|